Rangemaster Nexus Dual Fuel User's Guide Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
4
ArtNo.311-0007 Wok stand close-up
ArtNo.311-0006 Correct wok sizes
ArtNo.311-0002 Pan with rim
ArtNo.311-0001 Right pans gas
Art No. 311-0003 Simmer aids
ArtNo.311-0004 Tipping wok
The igniter should spark and light the gas. Continue to press
in the knob to let the gas through to the burner for about ten
seconds.
If and when you let go of the control knob or the burner goes
out, then the FSD has not been bypassed. Turn the control
knob to the OFF position and wait for one minute before you
try again, this time making sure to hold in the control knob
for slightly longer.
Adjust the ame height to suit by turning the knob counter-
clockwise (Fig. 2.3). On this cooker the low position is
beyond high, NOT between high and o.
If a burner ame goes out, turn o the control knob and
leave it for one minute before relighting it.
Make sure that the ames are under the pans. Using a lid will
help the contents boil more quickly (Fig. 2.4).
Large pans should be spaced well apart.
Pans and kettles with concave bases or down-turned base
rims should not be used (Fig. 2.5).
Simmering aids, such as asbestos or mesh mats, are
NOT recommended (Fig. 2.6). They will reduce burner
performance and could damage the pan supports.
You should also avoid using unstable and misshapen pans
that may tilt easily, and pans with a very small base diameter,
e.g. milk pans, single egg poachers (Fig. 2.7).
The minimum recommended pan diameter is 120 mm. The
maximum allowable pan base diameter is 260 mm.
DO NOT use cooking vessels on the hotplate that overlap the
edges.
Wok Burner
The Wok Burner is designed to provide even heat over a large
area. It is ideal for large pans and stir-frying (Fig. 2.8).
For heating smaller pans, the aforementioned hotplate
burners may be more ecient.
You should wipe the enamel top surface of the cooker around
the hotplate burners as soon as possible after spills occur. Try
to wipe them o while the enamel is still warm.
Note:
The use of aluminium pans may cause metallic marking
of the pan supports. This does not aect the durability of the
enamel and may be cleaned o with a suitable metal cleaner.
The Wok Cradle (Optional)
The Wok Cradle is designed to t a 35 cm wok. If you use a
dierent wok, make sure that it ts the cradle. Woks vary very
widely in size and shape. It is important that the wok sits
down on the pan support – however, if the wok is too small,
the cradle will not support it properly (Fig. 2.8).
The cradle should be used on the wok burners only. When
you t the cradle, check that it is supported properly on a pan
support and that the wok is sitting level in the cradle (Fig.
2.10).
The cradle will get very hot in use – allow plenty of time for it
to cool before you pick it up.
Fig. 2.3
Fig. 2.4
Fig. 2.6
Fig. 2.5
Fig. 2.7
Fig. 2.8
Fig. 2.9
Fig. 2.10
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Comments to this Manuals

No comments