Rangemaster Nexus Dual Fuel User's Guide download pdf (Page 28)

INSTALLATION

Check the appliance is electrically safe and gas sound when you have nished.

ArtNo.010-0004 Moving the cooker

Lowering the Two Rear Rollers

To adjust the height of the rear of the cooker, rst t a 13 mm

spanner or socket wrench onto the hexagonal adjusting

nut (Fig.7.5). Rotate the nut – clockwise to raise – counter-

clockwise to lower.

Make 10 complete (360°) turns clockwise.

Make sure you lower BOTH REAR ROLLERS.

Completing the Move

Unfold the rear edge of the cardboard base tray. Open the

oven doors so that you can get a good grip on the bottom of

the fascia panel as you move the oven (Fig.7.6).

Carefully push the cooker backwards o the base tray.

Remove the base tray.

Position the cooker close to its nal position, leaving just

enough space to get behind it (Fig.7.7).



DO NOT use the door handles or control knobs to

manoeuvre the cooker.

Repositioning the Cooker Following

Connection

If you need to move the cooker once it has been connected

then you need to unplug it and, having gripped under the

fascia panel and lifted the front of the cooker slightly

(Fig.7.6); you need to check behind the cooker to make sure

that the gas hose is not caught.

As you progress, make sure that both the electricity cable and

gas hose always have sucient slack to allow the cooker to

move.

With a stability chain tted, release it as you ease the cooker out.

Do not forget to ret it when you replace the cooker.

When you replace the cooker, again check behind to make

sure that the electricity cable and gas hose are not caught or

trapped.

Fig.7.5

Fig.7.6

Fig.7.7

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

No comments

Rangemaster Nexus Dual Fuel User's Guide Page 28