Rangemaster Nexus Dual Fuel User's Guide download pdf (Page 29)

INSTALLATION

Check the appliance is electrically safe and gas sound when you have nished.

ArtNo.070-0014 - Stability bracket - Wall fitting

Cooker

Stability bracket

Floor

3 mm min

Typical oor mounting

Cooker

Outer stability

bracket

Floor

Wall

3 mm min

Typical wall mounting

Fitting the Stability Bracket or Chain

Unless otherwise stated, a cooker using a exible gas

connector must be secured with a suitable stability device.

Suitable stability devices are shown in Fig.7.8, Fig.7.9 and

Fig.7.10.

If you are using a stability chain (Fig.7.8) then the chain

should be kept as short as is practicable and xed rmly to

the rear of the cooker.

If you are using a stability bracket (Fig.7.9 and Fig.7.10), then

adjust the bracket to give the smallest practicable clearance

between the bracket and the engagement slot in the rear of

the cooker.

Fit the bracket so that it engages as far as possible over the

chassis of the cooker.

Conversion to Another Gas

If the appliance is to be converted to another gas do the

conversion at this point. See the conversion section of these

instructions.

Levelling

You are recommended to use a spirit level on a shelf in one of

the ovens to check for level.

Place the cooker in its intended position taking care not to

twist it within the gap between the kitchen units as damage

may occur to the cooker or the units.

The front feet and rear rollers can be adjusted to level the

cooker.

To adjust the height of the rear of the cooker use a 13 mm

spanner or socket wrench to turn the adjusting nuts at the

front bottom corners of the cooker.

To set the front, turn the feet bases to raise or lower.

Fig.7.9

Fig.7.10

Stability chain

Fig.7.8

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Comments to this Manuals

No comments

Rangemaster Nexus Dual Fuel User's Guide Page 29

Comments to this Manuals

Related products and manuals for Cookers Rangemaster Nexus Dual Fuel