Rangemaster CLASSIC 110 GAS FSD User Manual download pdf (Page 21)

Make sure you lower BOTH REAR ROLLERS. There

are two adjusting nuts, one for each roller, at both the

front bottom corners of the cooker.

Unfold the rear edge of pack base tray. Carefully push

the cooker backwards off the pack base and into

position. Take care not to damage the power cable.

Push the cooker close to its ﬁnal position, leaving just

enough space to get behind it.

Levelling

You are recommended to use a spirit level on a shelf

in one of the ovens to check for level.

Place the cooker in its intended position taking care

not to twist it within the gap between the kitchen units

as damage may occur to the cooker or the units.

The rollers can be adjusted to level the cooker. To

adjust the height of the rear of the cooker use the

levelling tool supplied to turn the adjusting nuts at the

front bottom corners of the cooker.

Adjust the height of the front roller to level the cooker.

Turn clockwise to raise the cooker and anticlockwise

to lower.

When you are satisﬁed with the height and level

raise the front of the cooker by one turn of the front

roller adjuster. Screw down the front feet to meet the

ﬂoor. Screw the front roller adjuster anticlockwise to

raise the front roller so that the front of the cooker is

supported on the feet, not the front roller, to prevent

accidental movement of the cooker.

Leave the levelling tool on the adjuster with the

handle of the tool facing the rear of the cooker, so

that the customer can use it if they wish to move

the cooker.

Replace the drawer by locating on side runners and

push in.

Moving the Cooker

The cooker is very heavy. Take great care.

We recommend two people manoeuvre the cooker.

Ensure that the ﬂoor covering is ﬁrmly ﬁxed, or

removed to prevent it being disturbed when moving

the cooker around. You will need the levelling tool.

From the back tilt the cooker forward and remove the

rear half of the polystyrene base pack.

Repeat from the front and remove the front half of the

poly base. Pull the drawer out to its furthest point. Lift

it up and out.

Fit the levelling tool on the rectangular adjuster as

shown below.

LOWER THE FRONT ROLLER by doing 14 complete

(360º) turns clockwise. (This means turning and

removing the levelling tool 56 times).

Now LOWER THE TWO REAR ROLLERS.

First ﬁt the levelling tool on the hexagonal adjusting

nut as shown below.

Make 10 complete (360º) turns clockwise. (This means

turning and removing the levelling tool 20 times).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Rangemaster CLASSIC 110 GAS FSD User Manual Page 21

Comments to this Manuals

Related products and manuals for Kitchen & houseware accessories Rangemaster CLASSIC 110 GAS FSD