Rangemaster Toledo XT 110 Dual Fuel User's Guide download pdf (Page 20)

Fig.5-5

Control Panel and Doors

Avoid using any abrasive cleaners including cream cleaners.

For best results, use a liquid detergent.

The same cleaner can be used on the doors or alternatively,

using a soft cloth wrung out in clean hot soapy water – but

take care that no surplus water seeps into the appliance.

After cleaning, polish with a dry cloth.

Ovens

Glass Fronted Door Panels

The oven door front panels can be taken o so that the glass

panels can be cleaned. Move the cooker forward to gain

access to the sides (see the ‘Moving the Cooker’ section under

‘Installation’). Open the oven door slightly and remove the

front panel xing screws from the door sides, two each side

(Fig.5-5).Carefully lift o the outer door panel. The inside

face of the glass panels can now be cleaned – take care not to

disturb or wet the door insulation.

Note: If the door is triple glazed then the inner two panels are

xed together and should not be separated.

After cleaning, carefully ret the outer door panel and replace

the side xing screws.



DO NOT use harsh abrasive cleaners or sharp metal

scrapers to clean the oven door glass since they can

scratch the surface, which may result in shattering of

the glass.

‘Cook & Clean’ Panels

The ovens have side “Cook & Clean” panels which have been

coated with a special enamel that partly cleans itself. This

does not stop all marks on the lining, but helps to reduce

the amount of manual cleaning needed. These panels work

better above 200 °C. If you do most of your cooking below

this temperature, occasionally remove the panels and wipe

with a lint free cloth and hot soapy water. The panels should

then be dried and replaced and the oven heated at 200 °C for

about one hour. This will ensure the “Cook & Clean” panels are

working eectively.

Do not use steel wool, oven cleaning pads, or any other

materials that will scratch the surface.

Removing the Oven Linings

Some of the lining panels can be removed for cleaning.

If you wish to clean the enamel interior of the oven, you

will need to remove the shelves before removing the ‘Cook

& Clean’ panels. You do not have to remove the support

brackets to remove the panels. Lift each panel upward and

slide forward o the support brackets (Fig.5-6).

Once the panels have been removed, the oven enamel

interior can be cleaned.

Ret in the reverse order.

ArtNo.320-0002b

- Oven door side screws (Toledo)

Fig.5-5

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Comments to this Manuals

No comments

Rangemaster Toledo XT 110 Dual Fuel User's Guide Page 20

Comments to this Manuals

Related products and manuals for Kitchen & houseware accessories Rangemaster Toledo XT 110 Dual Fuel