Rangemaster Nexus 110 Dual Fuel User's Guide download pdf (Page 32)

INSTALLATION

Check the appliance is electrically safe and gas sound when you have nished.

ArtNo.070-0014 - Stability bracket - Wall fitting

Cooker

Stability bracket

Floor

3 mm min

Typical oor mounting

Cooker

Outer stability

bracket

Floor

Wall

3 mm min

Typical wall mounting

Repositioning the Cooker Following

Connection

If you need to move the cooker once it has been connected

then you need to unplug it and, having gripped under the

fascia panel and lifted the front of the cooker slightly

(Fig. 7.6); you need to check behind the cooker to make sure

that the gas hose is not caught.

As you progress, make sure that both the electricity cable and

gas hose always have sucient slack to allow the cooker to

move.

With a stability chain tted, release it as you ease the cooker out.

Do not forget to ret it when you replace the cooker.

When you replace the cooker, again check behind to make

sure that the electricity cable and gas hose are not caught or

trapped.

Conversion to Another Gas

If the appliance is to be converted to another gas do the

conversion at this point. See the conversion section of these

instructions.

Levelling

You are recommended to use a spirit level on a shelf in one of

the ovens to check for level.

Place the cooker in its intended position taking care not to

twist it within the gap between the kitchen units as damage

may occur to the cooker or the units.

The front feet and rear rollers can be adjusted to level the

cooker.

To adjust the height of the rear of the cooker use a 13 mm

spanner or socket wrench to turn the adjusting nuts at the

front bottom corners of the cooker.

To set the front, turn the feet bases to raise or lower.

Fig. 7.9

Fig. 7.10

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments

Rangemaster Nexus 110 Dual Fuel User's Guide Page 32

Comments to this Manuals

Related products and manuals for Cookers Rangemaster Nexus 110 Dual Fuel